Choose a state

TX-MP Master Plumber (2008-11-30)

210 Questions

The reference material listed below was used to prepare the questions for this examination.  The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available.  For Code questions, the examinations will be based only on the edition of the Code book that is listed.

These products apply to test outline dated 2008-11-30



Open Book These books are allowed while taking your test.
Closed Book These books are for pre-test study only and are not available for use during the test.

  • Closed Book

    International Plumbing Code Turbo Tabs 2009

    Publication Year: 2009

    $12.93

    Flip through the 2009 I-Codes series and find frequently used sections fast! You'll be surprised how easy it is to find what you are looking for. These tabs were created by industry experts who carefully identified the most referenced sections in the code.

  • Closed Book

    International Plumbing Code 2009

    Publication Year: 2009

    $66.48

    Provides comprehensive minimum regulations for plumbing facilities in terms of both performance and prescriptive objectives, and provides for the acceptance of new and innovative products, materials and systems.

  • Closed Book

    International Fuel Gas Code Turbo Tabs 2009

    Publication Year: 2009

    $12.93

    Flip through the 2009 I-Codes series and find frequently used sections fast! You'll be surprised how easy it is to find what you are looking for. These tabs were created by industry experts who carefully identified the most referenced sections in the code.

  • Closed Book

    International Fuel Gas Code 2009

    Publication Year: 2009

    $65.00

    1 - Scope and Administration, 2 - Definitions, 3 - General Regulations, 4 - Gas Piping Installations, 5 - Chimneys and Vents, 6 - Specific Appliances, 7 - Gaseous Hydrogen Systems, 8 - Reference Standards, Appendix A - Sizing and Capacities of Gas Piping, Appendix B - Sizing of Venting Systems Serving Appliance Equipped with Draft Hoods, Category 1 Appliances and Appliances Listed for Use with Type B Vents, Appendix C - Exit Terminals of Mechanical Draft and Direct-vent Venting Systems, Appendix D - Recommended Procedures for Safety Inspection of an Existing Appliance Installation.

  • Closed Book

    Texas Plumbing Licensing Law Rules

    $9.15