Choose a state
C-1G Pipes and Vents for Gas Contractor (2023-11-01)
11/01/2023The installation of pipes from the source of supply of liquefied petroleum and natural gas into a building or structure and the installation of the related vents.
50 Questions
70% Minimum Passing Score
2 Hours,
The reference material listed below was used to prepare the questions for this examination. The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available. For Code questions, the examinations will be based only on the edition of the Code book that is listed.
Click Here to View the Candidate Information Bulletin
Open Book These books are allowed while taking your test.
Closed Book These books are for pre-test study only and are not available for use during the test.
In Stock These books are currently in stock.
Out of Stock These books are currently out of stock.
Closed Book These books are for pre-test study only and are not available for use during the test.
In Stock These books are currently in stock.
Out of Stock These books are currently out of stock.
-
-
Open Book In Stock
NFPA 54: National Fuel and Gas Code 2012 Edition
Publication Year: 2012
$150.00
2012 NFPA 54: National Fuel Gas Code provides revised, industry accepted guidance for the safe installation and operation of gas piping systems, appliances, equipment, and accessories.
-
Open Book In Stock
NFPA 58: Liquefied Petroleum Gas Code 2014
Publication Year: 2014
$150.00
Liquefied Petroleum Gas Code provides minimum safety requirements for all liquefied petroleum gas (propane) installations, from small cylinders installed at residences to large bulk storage facilities that can exceed 100,000 gallons. The code includes minimum requirements for safe handling during LP gas transfer, including operator qualifications, maximum filling quantity in containers, and pre-transfer inspections to ensure containers are fit for continued service.
-
Open Book In Stock
Uniform Mechanical Code 2018
Publication Year: 2018
$147.00
The 2018 edition of the Uniform Mechanical Code (UMC©) represents the most current approaches in the mechanical field. It is the sixth edition developed under the ANSI Consensus process is designated as an American National Standards by the American National Standards Institute (ANSI). The 2018 edition of the UMC reached a major milestone as it addresses specific provisions for low flammability refrigerants such as A2L and B2L; which makes it one of the first codes in the industry to address specific provisions for these low Global Warming Potential (GWP) refrigerants. Contributions to the content of this code were made by every segment of the built industry, including such diverse interests as consumers, enforcing authorities, installers/maintainers, labor, manufacturers, research/standards/ testing laboratories, special experts and users.
