Choose a state
C-77 (CR-77) Plumbing, Including Solar (Commercial) (2023-06-08)
Installation, alteration and repair of all plumbing, including solar, when performed solely within property lines and not on public easements or right-of-ways except as hereinafter provided.
Installation, alteration and repair of all piping, fixtures and appliances related to water supply, including pressure vessels and tanks (excluding municipal or related water supply systems); venting and sanitary drainage systems for all fluid, semi-fluid and organic wastes; septic tanks and leaching lines; roof leaders; lawn sprinkler systems; water conditioning equipment; piping and equipment for swimming pools.
Also included are piping, fixtures, appliances and pressure vessels for manufactured and natural gases, compressed air and vacuum systems, petroleum, fuel oil, non-potable liquids, hot water heating and hot water supply systems operating at pressures not exceeding 30 psig or temperatures not exceeding 220°F; steam heating and steam supply systems not exceeding 15 psig operating pressure; gas- or oil-fired space heaters and furnaces excluding duct work. Piping for water cooling systems excluding the refrigerant piping and equipment. Testing and balancing of hydronics systems.
Sewer, gas, water lines and connections from structure to the nearest point of public supply or disposal may cross public or private easements or be installed within private easements. Pipe installed across public property may not be increased in size or make any other connection between the point of exit from private property to point of connection at public supply or disposal. These lines shall not be installed parallel to main lines in public easements or right-of-ways.
100 Questions
70% Minimum Passing Score
240 Minutes Time Allowed
Additional Solar Test Required
30 Questions
70% Minimum Passing Score
75 Minutes Time Allowed
The reference material listed below was used to prepare the questions for this examination. The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available. For Code questions, the examinations will be based only on the edition of the Code book that is listed.
These products apply to test outline dated 2023-06-08Click Here to View the Candidate Information Bulletin
Closed Book These books are for pre-test study only and are not available for use during the test.
In Stock These books are currently in stock.
Out of Stock These books are currently out of stock.
-
Open Book In Stock
On-site Wastewater Treatment Facility Provisions in Unified Water Quality Permit Rule, AZ Admin Code, Title 18, Chapter 9
Publication Year: 2006
$18.47
-
Closed Book In Stock
Arizona 811: Arizona Blue Stake Inc (English)
July Edition
Publication Year: 2010
This booklet was published with the intent of assisting the excavator utilizing the special services of Blue Stake. It is not intended to be used as an interpretation of state law or as an industry standard. This booklet will be revised from time to time without notice.
-
Open Book In Stock
International Plumbing Code 2018
Publication Year: 2018
$100.00
The IPC provides minimum regulations for plumbing facilities in terms of both performance and prescriptive objectives, and provides for the acceptance of new and innovative products, materials, and systems. Important changes include: Updated table for the Minimum Number of Required Plumbing Fixtures. Single-user toilet facilities (a room having a single water closet and a single lavatory) are not required to be labeled for use by only a male or female (separated use designations). Solar thermal water heating systems need to conform to the ICC 900/SRCC 300 standard. Well systems are required to comply with standard NGWA-01 where local requirements do not cover subject matter or are lacking in detail on others.
-
Open Book In Stock
International Plumbing Code Turbo Tabs 2018
Publication Year: 2018
$18.00
2018 IPC Turbo Tabs consist of clear plastic self-adhesive tabs that have key sections of the 2018 International Plumbing Code printed on them in an easy-to-read format. Can be used with either the 2018 International Plumbing Code or the 2018 IPC Code and Commentary.
-
Open Book In Stock
International Fuel Gas Code Turbo Tabs 2018
Publication Year: 2018
$18.00
2018 IFGC Turbo Tabs consist of clear plastic self-adhesive tabs that have key sections of the 2018 International Fuel Gas Code printed on them in an easy-to-read format. Can be used with either the 2018 International Fuel Gas Code or the 2012 IFGC Code and Commentary.
-
Open Book In Stock
International Mechanical Code Turbo Tabs 2018
Publication Year: 2018
$18.00
2018 IMC Turbo Tabs consist of clear plastic self-adhesive tabs that have key sections of the 2018 International Mechanical Code printed on them in an easy-to-read format. Can be used with either the 2018 International Mechanical Code or the 2018 IMC Code and Commentary.
-
Open Book In Stock
International Fuel Gas Code 2018
Publication Year: 2018
$100.00
2018 International Fuel Gas Code addresses the design and installation of fuel gas systems and gas-fired appliances through requirements that emphasize performance.
-
Open Book In Stock
International Mechanical Code 2018
Publication Year: 2018
$100.00
2018 International Mechanical Code establishes minimum regulations for mechanical systems using prescriptive and performance-related provisions. The code was developed with broad-based principles that make possible the use of new materials, methods, and design.
-
Open Book In Stock
NFPA 13D: Standard for the Installation of Sprinkler Systems in One- and Two-Family Dwellings and Manufactured Homes 2007
Publication Year: 2007
$145.00
This standard shall cover the design, installation, and maintenance of automatic sprinkler systems for protection against the fire hazards in one- and two-family dwellings and manufactured homes. 1.1.2 This standard assumes that the sprinkler system is designed to protect against a fire originating from a single ignition location.
-
Open Book In Stock
NFPA 13R: Standard for the Installation of Sprinkler Systems in Residential Occupancies up to and Including Four Stories in Height 2007
Publication Year: 2007
$145.00
This standard shall cover the design and installation of automatic sprinkler systems for protection against fire hazards in residential occupancies up to and including four stories in height. 1.1.1 This standard assumes that the sprinkler system shall be designed to protect against a fire originating from a single ignition location.
-
Closed Book In Stock
IPT's Pipe Trades Handbook
Publication Year: 1991
$45.00
IPT's Pipe Trades Handbook is North America's most popular and widely used reference book. It was revised in 2006 to 534 pages. Used for on-the-job reference as well as numerous training and apprenticeship programs.
-
Closed Book In Stock
Mathematics for Plumbers and Pipefitters 8th Edition
8th Edition
$210.00
Fully updated for optimal learning, Mathematics for Plumbers and Pipe-fitters, 8E remains a trusted resource for essential math concepts in the plumbing and pipe-fitting trades. With an emphasis on real-world examples that will prepare readers to successfully transfer their knowledge to on-the-job situations, this book utilizes the most currently used fitting materials to demonstrate key concepts. Simplified, clear explanations and a straightforward approach, combined with new units on changes of state, pressure and heat, and mechanical advantage, make this an ideal tool for anyone entering the field.
-
Open Book In Stock
Code of Federal Regulations, 29 CFR Part 1926 (OSHA) 2024
Publication Year: 2024
$32.00
The OSHA 29 CFR 1926 Construction Regulations book offers convenient access to vital safety guidance for both employers and employees, aiding in the prompt identification of potential hazards on any job site. Its user-friendly design features a two-color layout, simplifying navigation and comprehension of regulations. It encompasses all 1926 regulations, along with 1903 regulations on inspections, citations, and penalties, as well as 1904 regulations concerning record keeping and reporting of occupational injuries and illnesses. Additionally, select 1910 regulations relevant to construction industries are included. The book highlights regulation changes between releases and provides easy-to-access OSHA interpretations, aiding in clarity and reference. Essential documents such as OSHA Form 300 and the Cancer Policy are incorporated. In-Cite Referencing to applicable 1910 regulations is provided for further context. Lastly, the book outlines the Most Frequently Cited Standards preceding relevant Subparts, enhancing its utility as a comprehensive safety resource.
-
-
Open Book In Stock
NFPA 13: Standard for the Installation of Sprinkler Systems, 2016 Edition
Publication Year: 2016
$164.00
-
Closed Book In Stock
Modern Hydronic Heating & Cooling for Residential and Light Commercial Buildings 4th Edition
4th Edition
$250.00
From simple applications to multi-load and multi-temperature systems, this one-of-a-kind, comprehensive text prepares readers to use the latest hydronics to create systems that deliver the ultimate in comfort, reliability and energy efficiency. Abundantly illustrated with product and installation photos and hundreds of detailed, full-color schematics, MODERN HYDRONIC HEATING, Fourth Edition, transforms engineering-level design information into practical applications useful for technical students and heating professionals alike. The revised edition features the latest design and installation techniques for residential and light commercial hydronic systems, including use of renewable energy heat sources such as air-to-water and geothermal heat pumps, hydraulic separation, variable speed circulators, distribution efficiency, heat exchangers, buffer tanks, heat metering, hydronic cooling, system balancing and proper system documentation. Anyone involved in the heating trade will benefit from this preeminent resource of the North American heating industry, which is equally well-suited for formal education courses, self-study or on-the-job reference.